Shutting Down; Settings - Accu-Turn 1220 Manuel De L'opérateur

32
All manuals and user guides at all-guides.com
Operations
- switch the balancer on again.
• Carefully repeat the commands with the manual at
• Carefully repeat the commands with the manual at
hand.
• Call Accu Service immediately if the unit does not
hand.
• Call Technical Service immediately if the unit does
operate correctly:
not operate correctly:
WARNING: DO NOT ATTEMPT TO USE THE
WARNING: DO NOT ATTEMPT TO USE THE BALANCER IF START-UP SELF TEST IS NOT
BALANCER IF START-UP SELF TEST IS NOT SUCCESSFUL.
SUCCESSFUL.
5.2.3
5.2.3
Always shut down properly at the end of a work shift:
• Remove the wheel from the balancer.
Always shut down properly at the end of a work shift:
• Remove the cones and quick-release wing nut from • Remove the wheel from the balancer.
• Remove the cones and quick-release wing nut from
the stub shaft. Check the surfaces (internal and
external) of the cones for damage. The cone is very the stub shaft. Check the surfaces (internal and
important for a good balance quality. external) of the cones for damage. The cone is very
• Check the thread of the quick-release wing nut.
important for a good balance quality.
• Clean all threads and surfaces with a dry, soft cloth. • Check the thread of the quick-release wing nut.
• Clean all threads and surfaces with a dry, soft cloth. • Store the cones and the quick-release wing nut in
• Store the cones and the quick-release wing nut in
the correct place.
• Unplug the power cord from the power outlet.
the correct place.
• Check the power cord for damage or wear. • Unplug the power cord from the power outlet.
• Check the power cord for damage or wear.
• Clean up the weight storage areas.
• Clean the display and control panel with a soft, dry • Clean up the weight storage areas.
• Clean the display and control panel with a soft, dry
cloth.
• Remove old wheel weights and other material from
cloth.
• Remove old wheel weights and other material from
under the balancer. The balancer must rest stably on
its three feet only. under the balancer. The balancer must rest stably on
its three feet only.
5.2.4
5.2.4
When you switch on the unit, a balancing weight
When you switch on the unit, a balancing weight positioning mode is automatically shown. If the unit
comes up with a balancing weight application mode positioning mode is automatically shown. If the unit
different to the one you want, refer to Chapter 5.3.2. comes up with a balancing weight application mode
different to the one you want, refer to Chapter 5.3.2.
At power up, the units of measurement are ounces for
weight imbalance and inches for wheel parameters. At power up, the units of measurement are ounces for
weight imbalance and inches for wheel parameters.
Operator's Manual

Shutting down.

Shutting down.

Settings.

Settings.
ACCU 1220