The Control Panel - Accu-Turn 1220 Manuel De L'opérateur

2
1
3
5
7
8
10
4.2-1
18
All manuals and user guides at all-guides.com
Layout
4.2
Refer to Figure 4.2-1.
1.
To increase the balancers offset (distance between
the left side of the rim and the balancer cabinet)
shown on the display. Hold down this key to rapidly
increase the value.
2.
To reduce the offset between the internal side of the
4
rim and the balancer cabinet shown on the display.
Hold down this key to rapidly scroll the values.
6 If pressed during power up, will activate the user
calibration function CAL.
3.
Press this key to increase the rim width value shown
on the display.
9
4.
Press this key to reduce the rim width value shown
11
on the display.
If pressed in combination with the "F" key, will toggle
between readings in ounces (default setting) and
grams.
5.
Press to increase the rim diameter value shown on
the display. Essential key to increase the diameter
over the 24 inches. Hold down to rapidly move
through the values.
6.
Press to reduce the rim diameter value shown on
the display. Hold down to rapidly scroll through the
values.
In combination with the "F" key, toggles between
readings in inches (default setting) and millimeters.
7.
Press to select the balancing weight application
mode (clip weight or tape weight and it's position
on the rim). The LEDs on the control panel indicate
the balancing weight application combinations. The
unit emits a beep as you toggle through the options.
Hold down for 3 seconds to activate the function
"Quick ALU S".
8.
Press with the "- Gr/Oz" key to change from "Gr" to
"Oz". Press with the "- mm/inch" key to change from
"inch" to "mm". Press on its own and it acts like the
Enter key. Hold down for several seconds to activate
the OPT function. Hold down for several seconds
in combination with ALU button to activate Multiple
Operators function. Hold down for several seconds
in combination with FINE button to activate Counter
function.
9.
Press to toggle the reading precision between 0.25
and 0.1 oz. (5 and 2 grams) . The unit emits a beep.
10.
Press to start balancer cycle, with the wheel guard
down.
11.
Press to stop wheel rotation.
Operator's Manual

The Control Panel.

Rim Offset Key.
Rim Offset and Calibration Key.
Rim Width Key.
Rim Width and Gr/Oz Key.
Rim Diameter Key.
Rim Diameter and mm/inch Key.
ALU Key.
Multi-function Key.
FINE Key.
START key.
STOP key.
ACCU 1220