Accu-Turn 1220 Manuel De L'opérateur page 80

iii-4
80
All manuals and user guides at all-guides.com
Installation Instructions
Weight Tray Plane:
• Rest the weight tray plane on the machine and,
before securing it, pass the keyboard connecting
cables to the outside: the cables are fed in from
the bottom of the Weight Tray Plane and exit
through the top, where the keyboard will be
positioned.
• Fit the two side screws with metric pitch (1-Fig. iii-
4).
Fit the two black screws on the front (4-Fig. iii-4)
and tighten it normally on the case.
Control panel:
• Connect the multi-track cable to the connector
behind the panel.
• Connect the earth cable to the front panel.
• Apply the Control Panel, angled correctly, carefully
positioned at the centre of its seat on the Weight
Tray Plane.
• Press on the sides to make the Velcro tape adhere
correctly.
iv Test procedures.
• Balance a wheel to less than 0.25 oz. (5 grams)
per plane.
• Perform a User Calibration. See Chapter 6.3.1.
v Instructing the operator.
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
• Show the operator how to switch the unit on and
off.
• Show the operator how to perform an emergency
stop.
• Show the operator how to select a wheel type, enter
data and apply a weight.
Operator's Manual ACCU 1220