When You Want To Change The Type Of Massage - Panasonic EP-MAC8 Mode D'emploi

"AUTO" massage
(continued)
❷
Select course, press
It will automatically assume a
massage position
Reclined
approx. 18°
Massage
position
Raised approx. 35°
If you have reclined deeper than the massage
z
position, it does not automatically recline.
Please put your head against
the backrest
Massage
heads
When the pip pip pip sound is heard, the
massage heads rises slowly upwards.
It will stop after it has risen
to a point where the massage
heads hits the body less
Massage
heads
EN22
When the beep sounds, and
flashes, adjust the position of
the massage heads so that it fits
the shoulder position
● The figure shows the shoulder position in 19 levels.
【Shoulder position adjustment mode】
〈How to adjust〉
Max "19"
Adjust the
position with ▲ ▼
( )
Min "1"
Press once to
move about
1.5 cm (0.6 in.).
When shoulder position matched,
press , and the course starts
(Even if you do not press [OK], the course will start
after about 15 seconds.)
<Estimated shoulder
▪Reference
position>
Too high
Correct position
of the massage
head
( The point where
the tapping action
should be felt.)
Too low
After determining the shoulder position, the leg/
z
foot massage section may go up depending on the
height of a shorter person.
( In order to make the sole reach)
Shoulder position can be adjusted at any time
z
during "AUTO" massage operation.
(Cannot be adjusted during "MANUAL" massage)
Press ▲ ▼ during "AUTO" massage to switch to
z
shoulder position adjustment mode.
Be sure to put your head against
the backrest before starting
Please do not move your
z
head from the backrest until it
determines shoulder position.
Shoulder check operation will
not work, error indication (U10)
will appear and operation may
end.
Error display（EN38）
When you want to further
meet your needs
（EN30）
Screen examples
during course
Displays the selected
action, position of
"AIR / STRETCH"
Flashes during air massage
operation
Illuminate when
"SOLE HEAT" is "ON"
Displays the intensity of
the air
When you want to change
the type of massage
To select another course of "AUTO"
is pressed and course
is selected again
（EN21）
( All massages will be
temporarily suspended)
To change to "MANUAL"
is pressed and
type and action of
massage are selected
（EN25）
( All massages will be
temporarily suspended)
When changing only to "AIR / STRETCH"
is pressed to temporarily
stop massage,
is pressed
（EN28）
Displays the current course name
Approximate position currently being
massaged is flashing
Displays the time remaining
Illuminate when "HEAT" is "ON"
Displays the current activity
Displays the back intensity
EN23