Vertical Use - geo-FENNEL FL 190A Mode D'emploi

EN
HORIZONTAL USE
Set up the instrument on a flat smooth surface or
mount it onto a tripod.
Release the compensator clamp, which protects
the instrument from damages during transport, by
turning wheel (1) to ON until stop.
Press the ON/OFF button of the keypad. The instru-
ment will level automatically within the self-levelling
range of ± 3°. The laser head starts rotating. Select
the rotating speed with button (6) of the keypad. The
LEDs will show the rotating speed selected: LED
H = (600 rpm), LED M (= 400 rpm), LED
L (= 200 rpm).
An audible signal indicates if the instrument was set
up outside of the compensator range of ± 3°. The
laser head stops rotating. Set up the laser on a more
even surface.

VERTICAL USE

Center the vial
For vertical use it is absolutely required to set
the compensator clamp (1) to OFF .
Set up the instrument with its wallmount on a
flat smooth surface or mount it onto a tripod
with its 5/8" thread.
Center the vial for vertical application by
1
means of the foot screw (8). Take care to set
the vial very precisely as the compensator will
not work in vertical mode.
For the functions please see „horizontal use" .
NOTE
During transport and in vertical use the com-
pensator clamp must be set to OFF . Disregard
may lead to damage of the unit!
13