Cutting With The Pt-32Eh; Important - ESAB PT-32EH Manuel D'instruction

sEctIoN 4
WarNINg
WarNINg

4.2 cuttINg WIth thE pt-32Eh

Use the following procedures to cut with the PT-32EH torch (Figure 4-4).
1. Make sure that the wall disconnect switch is on. Turn on the Power Switch to the cutting power source console.
2. Set Pressure Regulator to 75 - 80 psig (5.2 - 5.5 bar).
3. Hold the torch nozzle approximately 1/8 in. to 3/16 in. (3.2 mm-4.7mm) above the work and tilted at about 15 - 30°.
This reduces the chance of spatter entering the nozzle. If the PT-32EH's standoff guide P/N 0558002393 is being
used, the distance between Electrode and Work Piece will be approx. 3/16 in. (.47 mm).
4. Depress the torch switch. Air should flow from the torch nozzle.
5. Two seconds after depressing the torch switch, the pilot arc should start. The main arc should immediately follow,
allowing the cut to begin. (If using the trigger LOCK mode, torch switch may be released after establishing the
cutting arc.)
6. After starting the cut, the torch should be maintained at a 5-15° forward angle (Figure 4-2). This angle is especially
useful in helping to create a "drop" cut. When not using the standoff guide, the nozzle should be held approximately
1/4 in. (6.4 mm) from the work.
5˚ to 15˚
cut DIrEctIoN
figure 4-2. proper torch angle

IMportaNt!!!

Maintain proper
stand-off Distance
power output increases
with stand off Distance!
3/16 - 1/4 Inch
(4.7 - 6.4 mm)
figure 4-3. standoff vs. power output
ElEctrIc shocK can kill.
• Do NOT operate the unit with the cover removed.
• Do NOT apply power to the unit while holding or carrying the unit.
• Do NOT touch any torch parts forward of the torch handle (nozzle, heat
shield, electrode, etc.) with power switch on.
arc raYs can burn eyes and skin;
NoIsE can damage hearing.
• Wear welding helmet with No. 6 or 7 lens shade.
• Wear eye, ear, and body protection.
figure 4-4. piercing & cutting techniques using the pt-32Eh
76
opEratIoN