Technical Data; Assembly; Commissioning; Operation - Gloria Thermoflamm bio Fix Mode D'emploi

4

Technical data

Thermoflamm bio fix
Item nummer:
Voltage:
Output:
Heating system:
Max. temperature at the heating elements:
Heating time:
Weight:
Total height:
Protection class:
5

Assembly

NOTE!
After removing from the packaging, assemble both parts of the tubes (F) together, as
illustrated . When assembling, make sure that the attachment lug fits into the
2
groove as illustrated to ensure that both tubes (F) are in the correct position and the
handle (A) is aligned correctly.
Now tighten the screw connection (E) by hand by turning it clockwise.
6

Commissioning

WARNING! Danger or death by fire and/or explosion!
Improper use of the device poses a risk of serious injury or death! You should therefore
observe the following safety instructions:
Only operate the device in the open air.
Never direct the device at the connection cable or at flammable or explosive substances.
Place the device on non-flammable ground.

6.1 Operation

Figures 3 - 7
Slide the loop of the extension cable into the designated „cable cleat" B in the „handle" A
3
and fix it in the designated clip (see Figure 3).
NOTE!
The performance of the equipment may decrease if unnecessarily long extension cables
(>25 m) are used.
If cable reels are used, unroll the entire cable.
The cross-section of the cable used must be 1.5 mm
000174.0000
230 V ~ / 50 Hz
1.100 Watt
Hot air stream
800 °C
1,5 Min.
2.0 kg (without Chilling system)
100 cm
2 .
23