Getting Started - TechniSat DigitRadio 80 Mode D'emploi

Technisat

Getting Started

Carefully remove your radio from the box. You may wish to store the packaging for future use.
What you can find inside of your package
! Main unit
! Power adapter
! Wire antenna
! Converter
! Instruction manual
Positioning your Radio
Place your radio on a flat / stable surface that is not subject to vibrations.
Avoid the following locations:
! Where the radio will be exposed to direct sunlight.
! Where the radio will be close to heat radiating sources.
! Where the humidity is high and ventilation is poor.
! Where it is dusty.
! Where it is damp or there is a possibility of water dripping or splashing onto unit.
Adjusting the Antenna
Extend the antenna to ensure you receive the best reception possible in both DAB and FM radio
modes. It may be necessary to adjust the position of the radio and /or antenna to achieve the best
signal.
Using Headphones
You will require headphones fitted with a 3.5 mm diameter stereo plug. The Headphones socket is
located on the front of this unit. Headphones are not supplied with this radio.
Turn down the volume before connecting headphones. Slowly raise the volume with the headphones
on until you reach your desired level.
Caution: long-term exposure to loud music may cause hearing damage. It is best to avoid extreme
volume when using headphones, especially for extended periods of time.
Turning the Unit On/Off
Connect the plug at the end of power adapter cable to the DC IN socket on the back of the unit. Then
insert the power adapter into the mains socket. Press
the unit off completely, unplug the power adapter from the mains socket.
Volume Control
Adjust the radio volume by turning the VOLUME knob.
4
button to turn unit on or standby. To switch
DigitRadio 80