Changing Units; Key Reference; Normal Operation; Simulate - Navman REPEAT 3100 Notice De Montage Et D'utilisation

NMEA mode
NMEA Mode displays one item of data at a time from
any compatible NMEA instrument. To select which
NMEA data can be displayed, see section 5-2,
step 2. To change the item displayed, press
one or more times.

2-4 Changing units

To change the units on the REPEAT 3100, change
the units on the instrument which sends the data to
the REPEAT 3100.

2-6 Key reference

Turn power on
+
Hold
Turn Simulate
on or off
Hold
+
Reset to factory
defaults
5 sec

Normal operation

+
+
Change display mode, between
+
Dual mode, Wind mode and
NMEA mode
Change item of data displayed
Change item of data displayed
Adjust backlight
(4 levels or off)
6

2-5 Simulate

Simulate allows you to become familiar with the
REPEAT 3100 off the water. When simulate is on,
the unit functions normally except that the data from
or
other instruments is ignored and the unit generates
this data internally. The word SIM flashes at the
bottom, right corner of the screen if:
The REPEAT 3100 has simulate on.
Any instrument connected to the REPEAT
3100 by the NavBus has simulate on.
To turn simulate on or off in the REPEAT 3100:
1 Turn the power off.
2 Hold down
Setup
Set Backlight
Group
+
Select NMEA
data to display
+
Set UTC offset
(for time display)
+
NAVMAN
+
while you turn the power on.
Increase value
or change
NMEA item
+
Decrease value
or change
NMEA item
Turn NMEA
+
function display
+
ON or OFF
Return to
normal
operation
+
REPEAT 3100 Installation and Operation Manual