Risco RP432KPP2 Manuel D'installation page 8

Keypad Settings
Note: The following settings must be defined individually for each
keypad connected to the system.
To define keypad settings when idle follow this procedure:
1. Press for two seconds until the Keypad Settings menu appears
2. Select the relevant icon using the
3. Press .
4. Press the
5. Press to save the adjustment.
6. Press to exit the keypad settings.
Proximity Tag Operation
Present the Proximity Tag to the
keypad (after waking the keypad) as
shown in the following illustrations:
Automatic Upgrade Resulting from Panel Manual Upgrade
Upon initiation of the LightSYS2 panel remote upgrade (See LightSYS2 Installer
Manual, Appendix I: Remote Software Upgrade), the keypad software may
automatically also be upgraded. During this approximately three-minute process
Numerical keys that are used to input numeric codes (arming,
disarming or used to activate specific functions)
Brightness
Contrast
Keypad's buzzer volume
keys to adjust the level settings.
keys:
Figure 8
8