Risco RP432KPP2 Manuel D'installation page 4

Figure 3
* Used for tamper
4. Connect the wires to the (AUX, COM and BUS) connector shown in Figure 7.
5. Mount the keypad to the mounting bracket (see Figure 4).
6. Insert the fastening screw to lock the keypad (see Figure 5).
Mounting on Gang Box (Optional):
1. Repeat steps 1 to 2 in the previous procedure.
2. Secure the mounting bracket to the Gang Box using the two screws as
illustrated in Figure 6.
3. Mount the keypad to the mounting bracket and insert the fastening screw to
lock the keypad
Figure 4
Figure 6
4
Figure 5