Risco 8 Zone Expander Document Technique

The RISCO 8 Zone Expander (RP432EZ8) enables to expand the number of wired zones in the LightSYS
and ProSYS Plus.
DIP Switches Settings
Switch 1-5 Defines the Zone Expander ID
number.
Switch 6-7 Not Applicable
Switch 8: Instead of a short between the
Tamper Bypass TMP/COM terminal block)
UKCA and CE EMC Compliance Statement:
Hereby, RISCO Group declares that this equipment is in compliance
with the essential requirements of the UKCA Electromagnetic
Compatibility Regulations 2016 and CE Directive 2014/30/EU.
For the UKCA and CE Declaration of Conformity please refer to our
website:
www.riscogroup.com
Zone Termination
Note:
:
The RP432EZ8 enables to define the end-of-line resistance of its zones. Selection is done through the software with the
following available options. The TEOL configuration is applicable for all versions of ProSYS Plus and LightSYS
Version 3 or later.
No
0
1
2
3
4
Technical Information
Current Consumption
Main Panel Connection
Dimensions
RISCO 8 Zone Expander
EOL DEOL No
Customized 5
2.2K 2.2K (Dflt) 6
4.7K 6.8K 7
6.8K 2.2K 8
10K 10K 9
20 mA typical, 100mA Maximum
4-wire BUS, 300 m from Main Panel
10.5 cm x 6.6 cm x 1.8 cm
(RP432EZ8)
EOL DEOL No
3.74K 6.98K 10
2.7K 2.7K 11
4.7K 4.7K 12
3.3K 4.7K 13
1K 1K 14
EOL DEOL TEOL
3.3K 3.3K
5.6K 5.6K
2.2K 1.1K
2.2K 4.7K
4.7K 6.8K 12K