Rockwell Automation Allen-Bradley PanelView 300 Instructions D'installation page 14

14 PanelView 300 Micro Terminal
Connecting to Controllers
This section lists the cables used by the PanelView 300 Micro to communicate
with Allen-Bradley controllers and to operate on a DH-485 or DeviceNet
network.
MicroLogix Controller
Point-to-Point Communications with a
MicroLogix 1000/1200/1500 controller
using either DF1 or DH485 protocol over an
RS-232 link.
SLC/PLC-5/ControlLogix Controller
Point-to-Point Communications with a SLC,
PLC-5 or ControlLogix processor or module
using either DF1 or DH485 protocol over an
RS-232 link.
Advanced Interface Converter (AIC+)
Point-to-point connection between the
PanelView 300 Micro and an AIC+ module
(Cat. No. 1761-NET-AIC). This connection
allows the DH-485 version of the 300
Micro to operate on a DH-485 network.
DeviceNet Interface (DNI)
Point-to-Point connection between a
PanelView 300 Micro and the DNI module
(Cat. No. 1761-NET-DNI). This connection
allows the DF1 version of the Micro 300 to
operate on a DeviceNet network.
41061-156-01(A)
Cable
1761-CBL-AM00, Series C
1761-CBL-HM02, Series C
2711-CBL-HM05, Series C
2711-CBL-HM10, Series C
Cables
1761-CBL-AP00, Series C
1761-CBL-PM02, Series C
2711-CBL-PM05, Series C
2711-CBL-PM10, Series C
Cables
1761-CBL-AM00, Series C
1761-CBL-APOO, Series C
1761-CBL-PM02, Series C
1761-CBL-HM02, Series C
2711-CBL-PM05, Series C
2711-CBL-HM05, Series C
2711-CBL-PM10, Series C
2711-CBL-HM10, Series C
Cables
1761-CBL-AM00, Series C
1761-CBL-HM02, Series C
2711-CBL-HM05, Series C
2711-CBL-HM10, Series C
Cable Length
0.5 meter (1.5 ft)
2 meter (6.5 ft)
5 meter (15 ft)
10 meter (30 ft)
Cable Length
0.5 meter (1.5 ft)
2 meter (6.5 ft)
5 meter (15 ft)
10 meter (30 ft)
Cable Length
0.5 meter (1.5 ft)
0.5 meter (1.5 ft)
2 meter (6.5 ft)
2 meter (6.5 ft)
5 meter (15 ft)
5 meter (15 ft)
10 meter (30 ft)
10 meter (30 ft)
Cable Length
0.5 meter (1.5 ft)
2 meter (6.5 ft)
5 meter (15 ft)
10 meter (30 ft)