Rockwell Automation Allen-Bradley PanelView 300 Instructions D'installation page 17

File Transfer Considerations
Because the communication port supports both runtime communications and
application transfers,you must make sure the port is set properly.
For successful communications, the PV300 Micro and the communicating device
must be set to the same communications settings and baud rate. The factory
default setting is 9600 baud.
Downloaded Baud Rate Changes - After a successful application download,
you may not be able to download another application. It is possible, the
downloaded application was configured with a different run-time communication
baud rate in the PanelBuilder32 software.
Run-Time Baud Rate Changes - After a successful application download, the
PanelView 300 Micro may not be communicating with the logic controller. It is
possible, the downloaded application was configured with a different
communication baud rate than the connected logic controller.
To adjust the baud rate, you can either:
• enter Configuration Mode on the terminal and select the Communication
Setup screen (looks similar to screen below). See page 18 to access
Configuration Mode.
Press F2 to change
baud rate setting.
• access the Communication Setup dialog from the Application Settings dialog
in PanelBuilder32 and then redownload the application to the PV300 Micro.
DF1 - Full Duplex
F1 Comms N/8/1
F2 Baud 9600
F4 EXIT
F3 MORE
PanelView 300 Micro Terminal
Current baud
rate setting.
Press F4 to save
setting and exit.
17
41061-156-01(A)