Kozy Heat Fireplaces KOMFORT ZONE KIT Mode D'emploi page 12

3.2.2 Combustible Wall Finish
• Figure 3.4 shows installation of combustible wall finish up to 1"
thick. This combustible material goes on any required non-
combustible materials as required in Figures 3.1 and 3.2 on page
10.
• This 1" (25mm) combustible material is able to go down to the
fireplace finishing edge.
• See Figure 3.3 on page 11 for up to 1" (25mm) thick
combustible material installation around the KZK air discharge
grille.
Combustible wall nish
up to 1" (25mm) thick may be
installed over cement board
Figure 3.4, KZK-158A Combustible Wall Finish with Surround
12 FACING AND FINISHING
Finishing Edge
Fireplace Enclosure Floor
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Komfort Zone Kit #KZK-158A R.2