Norcold NX61 Manuel D'installation page 14

- Turn each bent hinge over and attach it, with the screws, to the
opposite side of the other door.
- If you removed the bent hinge [275a] from the left side of upper
door, attach the bent hinge [275b] to the right side of the lower
door.
- If you removed the bent hinge from the right side of upper door,
attach the bent hinge to the left side of the lower door.
- With the handle latches and springs in place, turn each door handle
over and attach it, with the screws, to the opposite side of the other
door.
- Make sure that the latch and the spring are in each door handle.
- If you removed the door handle [70a] from the left side of upper
door, attach the door handle [70b] to the right side of the lower
door.
- If you removed the door handle from the right side of upper door,
attach the door handle to the left side of the lower door.
- Put a hinge bushing back into each door hinge.
4. Reinstall the doors:
- Turn the lower (straight) hinge pin [64] into each of the lower cabinet
hinges (See Art02389).
To prevent damage to the threads of the hinge pins, turn
NOTICE
the hinge pins by hand until tight and then tighten with a
7/16 inch wrench or a screwdriver.
Apply Loctite removable thread locker (blue) to
!
the threads of the hinge screws before assembly
CAUTION
to prevent loosening during use. Do not allow
Loctite to contact any of the plastic surfaces of the
refrigerator because it can damage those surfaces.
- Put each door down onto the lower hinge pin.
- Align the holes in the upper hinges and hold in this position.
- Turn the upper hinge pin [63] into the hinges of each door (See
Art02387).
- Put the storage bins in the doors.
- Close the doors
- Tighten the hinge pins.
5. Reinstall the control cover:
- Using screws, attach the control cover [270] to the refrigerator.
- If the unit is equipped with a plastic control facade, carefully push the snap-on control facade [271] onto the control cover
(See Art02386).
- You may hear a "click' sound or feel a "snap" in your fingers when the control facade fully engages into the control cover.
- If the unit is equipped with an adhesive control label, align the label with the conrol buttons and press into place.
Installation Manual 14
274b
70a
275b
274b
74
274a
275a
74
70b
274a
74
Art02391