Pan & Tilt Adjustments; Power Supply Connections - Eneo MPB-72M2812M0A Guide D'installation Rapide

CAUTION:
Extreme care should be taken NOT to scratch the window in front
of lens.
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Do not expose the camera directly to a strong light source such
as the sun or spot light.
Pan & Tilt adjustments
• Unlock the screw on the camera bracket through using the torque wrench supplied
• Set the camera's viewing angle then lock the screw on the bracket.
Adjustment of viewing angle with a bracket
1. Pan limit: Pan is limited to +/- 90°.
90° 90°
2. Tilt limit: Tilt is limited to 0°(2°) min ~ 90° max. for wall(ceiling) installation respec-
tively with reference to the wall(ceiling) when the inclination of camera module is
0°, that is, the image is aligned horizontally.
90°
on the wall
8
88°
on the ceiling
3. Inclination limit (Horizontal image alignment): Inclination limited to +/-90° max.
±90°

Power supply connections

Make sure the power is removed before the installation. Camera can work with either
24VAC or 12VDC, dual voltage power. Primary and secondary grounds are completely
isolated to avoid the possible ground-loop problems.
SDI output (Yellow)
Analog output (Black)
Power ( 24VAC/12VDC)
Please use the cable as provided with camera. If camera cable is cut and re-wired,
i
the transmission distance of video can be reduced. Especially SDI cable should not be cut
because it requires detailed wiring job and affects the transmission distance.
EN
AC AC
AC(+): 24VAC/12VDC
(+) (-)
AC(-): 24VAC/GND
9