Part Names; Installation Instructions - Eneo MPB-72M2812M0A Guide D'installation Rapide

Part names

Sunshield bolt
Sunshield
Lock/unlock
screw
OSD setup control cover
CAUTION
6
Power/Video
cable
Easy bracket
Bracket
Lock/Unlock screw
Torque wrench

Installation instructions

CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed. The easy bracket can not be installed on the ceiling.
i
2. Place the easy bracket on pre-drilled position and fix it through using mounting
screws(4x30mm). Skip this step when an easy bracket is not installed.
3. Route the power cable to the connecting place. Hook up the camera bracket with
the easy bracket as illustrated below.
4. Fix the camera bracket through using assembly screws (4x15mm).
5. Set the camera's viewing angle.
6. Put the sunshield to the camera unit and tighten the sunshield-bolts.
Mounting Screw 1: 4x30mm
Assembly Screw: 4x15mm
4
Torque Wrench
EN
1
2
3
Cable exit
7