MetalTech CLIMB-N-GO I-CNG Instructions De Montage Et Consignes De Sécurité page 5

OPERATIONAL GUIDE
HOW TO USE THE CLIMB-N-GO
1. Install all components of the Climb-N-Go on the scaffolding as described in the
"Installation" section on the following pages.
2. Place the drive wheels of the Climb-N-Go in the "Active lock" position. Unlock those
of the scaffolding if not already done.
3. Climb up the scaffolding from the opposite side where the Climb-N-Go is installed
to provide counterweight, whether using the ladder or the scaffolding access hatch.
4. Verify if the guardrail access doors are locked.
MULTIDIRECTIONAL JOYSTICK CONTROL
ACCELERATE
SPEED INDICATOR
(TROUBLESHOOTING INDICATOR)
LOW
5. Start the Climb-N-Go by pressing the power button on the multidirectional joystick
control.
6. Adjust the initial speed by pressing the speed acceleration or deceleration buttons
on the joystick. NOTE: The speed will always be reset to lowest when starting
Climb-N-Go.
7. To move the Climb-N-Go, push the joystick in the desired direction.
8. After using the device, turn off the Climb-N-Go by pressing the power button.
9. Climb down the scaffolding on the opposite side where the Climb-N-Go is installed.
POWER LIGHT
HORN
HIGH
POWER BUTTON
DECELERATE
FORWARD
LEFT RIGHT
BACKWARD
JOYSTICK
5