Operational Safety - MetalTech CLIMB-N-GO I-CNG Instructions De Montage Et Consignes De Sécurité

OPERATIONAL SAFETY

READ CAREFULLY BEFORE USING THIS PRODUCT.
FAILURE TO UNDERSTAND AND FOLLOW ALL SAFETY RULES AND ASSEMBLY
INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
WARNINGS
Do not use this equipment if you are in poor health, taking medication,
drugs, or have been consuming alcohol, all of which may impair your ability
to work safely with this product.
Always use this product in conformity with local or national legislation which
applies.
Respect any applicable local or national legislation regarding the speed and
height of use of the Climb-N-Go with scaffolding.
Read and understand this entire manual before using this product. If you
have any questions, contact our customer service.
Follow all safety instructions and warnings of the scaffolding that will be
used with the Climb-N-Go.
Read and follow the manufacturer's operating and safety instructions of the
battery used with the Climb-N-Go.
Never climb up into the scaffolding if the Climb-N-Go wheels are not in
active lock mode.
Climb up or down the scaffolding from the opposite side where the
Climb-N-Go is installed to provide a counterweight whether using the ladder
or the access hatch.
Install the Climb-N-Go on the opposite side of the platform access hatch if
the scaffolding has one.
Always use scaffolding with a guardrail when using the Climb-N-Go.
This product is designed to be used and stored indoors.
The surface on which the scaffolding is moved must be less than 3 degrees
in slope, without pits, debris, holes or obstacles.
The Climb-N-Go is designed for use with a single scaffold. Do not use this
product to move stacked scaffolding units.
Acids are corrosive and can seriously affect strength. Do not expose the
Climb-N-Go to corrosive substances.
Metaltech declines all responsibility for damage to batteries caused by using
this product, to the Climb-N-Go or t its components by improper use of the
product.
2