MetalTech CLIMB-N-GO I-CNG Instructions De Montage Et Consignes De Sécurité page 7

INSTALLATION
6. To install the Climb-N-Go wheels more easily, slide a one-inch-thick (1 in.) piece of
wood under the scaffolding casters.
7. Temporarily remove the locking-pins from the scaffolding casters.
8. Position the wheels of the Climb-N-Go at the bottom of the scaffolding ladder.
Secure them using the locking-pins provided.
9. Put back in place the locking-pins of the scaffolding casters.
10. Tighten the tightening knob firmly so that the scaffolding and the Climb-N-Go
wheels are perfectly lined up and in contact.
NOTE: To install the Climb-N-Go on a BuildMan (I-BMSS) scaffolding, first unscrew and
remove the yellow adapter first.
8
9
7
6
10
NOTE: To install the Climb-N-
Go on a BuildMan (I-BMSS)
scaffolding, first unscrew and
remove the yellow adapter first.
7