MetalTech CLIMB-N-GO I-CNG Instructions De Montage Et Consignes De Sécurité page 3

ELECTRONIC SAFETY RULES
Do not expose batteries, cables or other electronic components to outdoor
weather or wet conditions.
Do not use this product with defective or damaged batteries.
Never use the cables for carrying, pulling, or unplugging the electrical device.
Keep cables away from heat or sharp edges.
Make sure that all cables are properly affixed to the scaffolding, so that they
will not be rolled on, tripped over or subject to damage while in use.
Always disconnect the battery from the Climb-N-Go before making any
adjustments or repairs.
Do not use with a damaged cable or any other damaged electronic
component.
Replace immediately any damaged parts with official replacements parts
from Metaltech. Do not use until the damaged parts have been replaced.
Do not disassemble or modify the electronic components inside the Climb-
N-Go other than for replacing defective parts.
The cables must be plugged into the connectors, respecting their orientation.
Never modify a connector or apply excessive force when connecting.
Metaltech declines all responsibility for damages caused to batteries with
the use of this product.
SPECIFICATIONS
WEIGHT
RANGE
HAULING CAPACITY
BATTERY VOLTAGE
CAN BE POWERED BY
COMPATIBLE INTERIOR
SCAFFOLDING
COMPLIANCE
All trademarks listed above, including DeWalt, Makita, Milwaukee, Porter Cable, Black & Decker and Stanley are the property of their
†
respective owners. Neither Metaltech nor its products are in any way affiliated with, authorized with or have been tested, certified or
approved by any of the companies or trademarks listed above, including for use with any of these companies' batteries.
55.1 LB (25 KG)
4,500 FT (1,372 M) (tested with 20V 4.0Ah battery)
330 LB (149.7 KG)
18-21V (NOT INCLUDED)
DEWALT®, MAKITA®, MILWAUKEE®, STANLEY®, PORTER CABLE®, BLACK & DECKER®
†
METALTECH BAKER TYPE SCAFFOLDING; I-CISC, I-CISCH1, I-CISCTP , I-CISCPY,
I-CISCMT, I-CAISC AND I-BMSS
MEETS OSHA STANDARD 1926.452(W)
†
3