Technical Data - MW TOOLS OD68 Mode D'emploi

TOOLS

Technical data

Dimensions:
Adjustable height:
Tank capacity:
Weight:
Owner/operator responsibility
It is the owner/operator responsibility to properly use and maintain this equipment. The instructions and
warning contained in this manual shall be read and understood by the owner/operator prior to operating this
equipment.
If and owner/operator does not understand English, the contents of this manual shall be explained in the
owner/operators native language to assure that the owner/operator comprehends.
Notice
This device dispenses fluid using pressurized air, and complies with the specifications of the Uniform Code.
Standard Fire Prevention Code and the National Fire Protection Association (NFIPA-30). It does not comply
with current provisions of BOCA section F-3203.5.3 You should consult your local fire Marshall concerning
code compliance of this device.
Inspection
Prior to operation or maintenance, a visual inspection shall be made. Check for worn parts, air leaks, and
damaged, loose or missing parts. Check tank operation by connecting air to air nipple and closing ball valve.
Verify that there is sufficient air flow coming from nozzle/hose assembly. If the equipment is damaged, badly
worn or operates abnormally, it should be removed from service. Contact a factory authorized service center
of repair. An annual tank/component inspection is recommended to be performed by a factory authorized
service center.
Warning
• Failure to heed the following may result in personal injury and/or property damage.
• NEVER leave unit unattended when operating or evacuating.
• NEVER use near open flame or heat source.
• ALWAYS raise drain bowl and close main valve before emptying.
• ALWAYS disconnect air supply after emptying.
• NEVER use unit for handling highly volatile fuels and fluids.
• USE ONLY the nozzle assembly provided.
• Failure to heed the following warning may result in personal injury and/or property damage. Pop-off
valve and present, non adjustable regulator have been installed for your protection. Do not tamper with or
remove.
• Never pressurize tank with ball valve open.
• If used oil does not evacuate tank upon pressurization; check that ball valve is fully closed, (handle in
horizontal position). If this does not correct the problem remove the unit from service immediately and
contact an authorized service center for repair.
• If the pop-off ever relieves ANY air pressure from the tank, remove the unit from service immediately and
contact an authorized service center for repair.
500 x 640 x 1780 mm
1170 - 1780 mm
68 l
23 kg
8
OD68 - NLFREN - v1.1 - 07092017
EN