Samson Carbon 61 Mode D'emploi page 15

Carbon 61 · USB/MIDI Keyboard Controller
Edit Mode
ASSIGN PEDAL
Press the ASSIGN PEDAL function key to adjust the controller number assigned to the
SUSTAIN PEDAL input. The default setting is CC #64. When pressed, the current controller
number will flash on the display. Rotate the DATA knob, or enter the controller number
(0–148) using the numerical keys. Refer to the MIDI Continuous Controller (CC) List on p.18
for a list of codes and their corresponding functions. Press the ENTER key to confirm your
selection. If the number input is out of range, the display will flash "-E-" (error) for three
seconds, before returning to the last set CC number.
Keyboard Settings
RESET ALL
The RESET ALL function sets all of the Carbon 61 controller values to their defaults. When you
press the RESET ALL function key, the display will first show "No" (indicating that you do not
want to reset all functions). If you do want to reset all controllers, press the numerical key 1,
or rotate the DATA knob until "Yes" appears on the display. Press the ENTER key to confirm,
and all controllers will be reset instantly. If you press the ENTER key while the display shows
"No", the reset will be cancelled.
ALL NOTES OFF
The ALL NOTES OFF function sends an "all notes off" message in order to stop any stuck
notes. Press the ALL NOTES OFF function key and the keyboard will instantly send the "all
notes off" message, and any sustaining notes should stop.
DEFAULT
The DEFAULT function returns all of the Carbon 61 parameters to the original factory settings.
Press the DEFAULT function key, and the display will show "No" (indicating that you do not
want to reset to all default, factory settings). If you do want to reset all controllers to their
factory settings, press the numerical key 1, or rotate the DATA knob until "Yes" appears on the
display. Press the ENTER key to confirm, and all controllers will be reset instantly. If you press
the ENTER key while the display shows "No", the reset will be cancelled.
SNAPSHOT
The SNAPSHOT function transmits all of the current controller values for the VOLUME fader,
DATA knob, PITCH BEND wheel, program number, and channel number at once, so that you
can get a full picture of your current settings. Press the SNAPSHOT key to view these values.
15