Quick Start - NEC MultiSync FE700 Mode D'emploi

Quick Start

To attach the MultiSync FE700 monitor to your system,
follow these instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information, refer to the
display card manual.
3. For the PC: Connect the
15-pin mini D-SUB of the
captive signal cable to the
connector of the display
card in your system (Figure
A.1). Tighten all screws.
For the Mac: Connect the
Macintosh Cable Adapter
(not included) to the
monitor connector on the
Macintosh (Figure B.1).
Attach the 15-pin mini
D-SUB end of the captive
signal cable to the
Macintosh cable adapter
on the computer (Figure
B.1). Tighten all screws.
Captive Signal Cable
Figure A.1
Computer Mac Adapter
(not included)
Figure B.1
E - 2
15-pin mini D-SUB
Captive Signal Cable
15-pin
mini D-SUB