Quick Start - NEC MultiSync A900 Manuel

Quick Start

To attach the MultiSync
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync A
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync A
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync A
NEC Technologies at (800) 820-1230.
4. For download information on the Windows
MultiSync A monitor, refer to the References section of this User's Manual.
900
5. Connect one end of the power cord to the MultiSync A
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
78133961.MultiL
All manuals and user guides at all-guides.com
A monitor to your system, follow
® ™
900
900
Macintosh cable adapter, call
900
Captive Signal Cable
Figure A.1
3
5
Macintosh cable adapter (not
95/98 INF file for your
®
monitor and the
900
15-pin mini D-SUB
9/10/98, 12:02 PM
900