Observations - Sagola 4600 Xtreme Manuel D'utilisation

30/31
Wear gloves when handling the product (see the manufacturer's recommendations) and clean the
gun.
If, when the gun is in use, the ambient noise level exceeds 85 dB (A) the use of approved ear
protectors is recommended.
The gun in itself does not propitiate any mechanical risk of perforations, impact or pinching,
except those deriving from incorrect installations and handling.
While work is in progress, no vibrations are transmitted from the gun to any part of the body of the
operator and reaction forces are minimal.
USE SAGOLA ANTISTATIC HOSES TO ELIMINATE POSSIBLE ELECTRICAL DISCHARGES THAT
MIGHT CREATE THE RISK OF FIRE OR EXPLOSION.
Pay adequate attention when handling the gun in order to prevent any damage that might lead
to dangerous situations for the user or personnel standing near the unit, as a consequence of
leaks, breakages, etc. Do not use it if your mental capacity, perceptions and reactions are altered
due to substances such as alcohol, drugs, medicines, etc., or by tiredness or for any other reason.
The gun has been designed for use at ambient temperature. Its maximum service temperature is
50°C. Although the air temperature of the compressed air or product is higher, this must not
exceed the maximum average temperature in the body of the gun. If the temperature exceeds
43°C, it is necessary to use personal protective equipment, such as gloves to thermally insulate
your hands from the unit.
The use of solvents and/or detergents that contain halogenated hydrocarbons (trichloroe-
thane, methyl chloride, etc.), may cause chemical reactions in the unit as well as in its
zinc-coated components (trichloroethane mixed with small amounts of water produces
hydrochloric acid). For this reason, these components may rust and in extreme cases the
chemical reaction caused may be explosive. We recommend you to use products that do
not contain the aforementioned components. Do not use acids, soda (alkalis or pickling
substances, etc.) for cleaning under any circumstances.
In general, precautions must be taken whenever the gun is handled, in order to prevent any
damage to this.
Connectors must be securely tightened and in good condition. If pneumatic connectors are fitted,
they must comply with the standard ISO 4414.
Safety standards must be understood and applied.
Any non-compliance with the indications set out in this manual may lead to incidents affecting the
physical integrity of the user or other personnel or animals.
Respect and comply with indications relating to the conservation of the environment.
Always keep the safety sheets for the products to apply and the cleaning liquids to hand in case
you need to consult them.

17. Observations

By following the instructions set out in this manual you will ensure good spraying and quality of
finish. Should you have any doubt, please contact the Technical Service of SAGOLA.
ENGLISH