Health And Safety - Sagola 4600 Xtreme Manuel D'utilisation

16. Health and Safety

In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the compres-
sed air distribution network.
Safe disconnection from the compressed air network:
If there is any cleaning liquid or product remaining in the tank, return it to its corresponding
container. If the pneumatic connector is fitted in the air inlet, disconnect the hose from the pistol.
If it is not, depressurise the air hose properly and, using a spanner, unscrew the end of the hose
from the air inlet connector, holding the pistol firmly.
Safe connection to the compressed air network:
If the pneumatic connector is fitted in the air inlet, connect the hose to the pistol. If it is not, hold
the pistol firmly and, using a spanner, screw the end of the hose into the air inlet connector. Check
there are no leaks.
Safe disconnection of the product tank:
Carry out the cleaning according to point 14. Disconnect the tank by unscrewing the product inlet
connector, holding the body of the pistol firmly.
Safe connection of the product tank:
Connect the tank by screwing on the product inlet connector, holding the body of the pistol firmly.
Check there are no leaks.
Never point the unit towards yourself, others or animals. The thinners and dilution media used
can cause serious injury.
We recommend using this unit in premises with forced ventilation and in accordance with the
current standards and provisions on the matter.
Near the unit, only keep the amount of product and thinner required for the work being done at
that time. After work has been completed, thinners and the product to be applied must be returned
to their corresponding storage location.
Keep the working area clean and free of potentially dangerous waste (thinners, rags, etc...).
While work is in progress, there must not be any source of ignition (naked flames, lighted cigaret-
tes, etc.) in the working area as these might generate easily flammable gases. Likewise, the
approved protective means must be used (breathing, hearing, etc.) in accordance with the
regulations established in this regard.
If the unit is used in an inadequate manner or its components are altered in any way severe
material damage may occur and bodily harm may be caused to the operator, other personnel
and/or animals and may even cause death. SAGOLA S.A. accepts no responsibility in for any
damage caused through the incorrect use of the unit.
THE BATTERY MUST NOT BE REPLACED IN HAZARDOUS AREAS.
See Atex regulations about explosion risk areas.
The battery housing and the pressure measurements sight glass must not be opened in a
location where there is any danger of explosion (EN 50020 standards. Do not change batteries in
a dangerous location Ex).
Always use approved breathing units in accordance with current Standards and Regulations in
order to protect yourself from emissions produced during application.
Never exceed the maximum air inlet pressure (8 bar). Excessive pressure will cause greater
environmental contamination. To provide the hose with compressed air for the pistol, fit a pressure
regulator and a safety valve.
As a general, preventive measure we advise you to wear goggles in accordance with the specific
environmental regulations and characteristics for the work centre.
ENGLISH