Exhaust Hose Installation; Important - Danby DPAC8511 Guide D'utilisation Et Soins De Propriètaire

Installation Instructions
EXHAUST HOSE
INSTALLATION:
The exhaust hose and adaptor must be installed or removed in
accordance with the usage mode.
COOL,HEAT(heat pump type) or AUTO mode
FAN, DEHUMIDIFY or HEAT (electrical heat type)
mode
1. Install the window Exhaust adaptor B onto the exhaust hose as shown
in Fig.17. or Fig.18. Refer to the previous pages for window kit
installation.
2. Push the Exhaust hose into the air outlet opening along the the arrow
direction (See Fig.19).
The exhaust hose can be installed into the wall
(Not applicable to the units without adaptor A, expansion plugs and
wooden screws in Accessories ).
1. Prepare a hole in the wall. Install the wall Exhaust adaptor A onto the
wall (outside) by using 4 expansion plugs and wooden screws, be sure
to fix thoroughly. (See Fig.20)
2. Attach the Exhaust hose to wall Exhaust adaptor A.
Note: Cover the hole using the adaptor cap when not in use.
• The duct can be compressed or extended moderately according to the
installation requirement, but it is desirable to keep the duct length to a
minimum.
DO NOT OVER BEND THE DUCT. (see Fig.21)
Fig.17 Fig.18
Expansion plug
position
Adaptor A
Adaptor
cap
Fig.20
13

IMPORTANT

Fig.19
Max 120cm
Min 30cm
Install
Remove
Fig.21