Danby DPA140HEAUBDB Guide D'utilisation Et D'entretien page 18

Installation Instructions
INSTALLATION IN A SLIDING SASH WINDOW
1. Measure the adhesive foam seal to fi t the windowsill. Cut the foam seal (adhesive type) to the proper length and
attach it to the window frame. See fi g. 13.
2. Adjust the length of the window slider kit according to the height of the window, shorten the adjustable window kit if
the height of the window slider is less than the opening. Open the window sash and place the window slider kit on the
windowsill. See fi g. 14.
3. Cut the foam seal (adhesive type) to the proper length and attach it to the top of the window. Shown in fi g. 15.
4. Close the sliding sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the open gap between the top window sash and outer window
sash. Shown in fi g. 16.
Window
Panel
Foam
Seal
15
Foam seal A
(adhesive type)
Fig.13
52 cm -
72 cm -2.07 m
2 m (28.3 - 81.5 in.)
Fig.14
Fig.15
Fig.16