Installation; Installation Hardware; Location - Danby DAC 5209M Guide D'utiliser Et Soins De Propriètaire

ELECTRIC SHOCK HAZARD: To avoid the possibility of personal injury, disconnect power to
the unit before installing or servicing.
TOOLS NEEDED FOR INSTALLATION:
Screw Drivers: Both Phillips and flat head
Power Drill: 1/8 inch diameter drill bit
Pencil
Measuring Tape
Your Room Air Conditioner is designed for easy
installtion in a single or double-hung window. This unit
is NOT designed for vertical (slider type) windows
and/or through-the-wall applications.
NOTE: Save the shipping carton and packing materials
for future storage or transport of the unit. From carton,
remove the plastic bag containing the installation
hardware kit necessary for the installation of your air
conditioner. Please check the contents of hardware kit
against the corresponding model check list, prior to
installation of the unit. See Fig. 1.
CAUTION: Because the compressor is located on
the controls side of the unit (left side), this side will be
heavier and more awkward to manipulate. Inadequate
support on control side of the unit can result in personal
injury and damage to your unit and property. Therefore, it
is recommended that you have someone assist you during
the installation of this unit.

LOCATION

A) This room air conditioner is designed to fit
easily into a single or double hung window.
However, since window designs vary, it may be
necessary to make some modifications for safe,
proper installation.
B) Make sure window and frame are structurally
sound and free from dry and rotted wood.
C) For maximum efficiency, install the air
conditioner on a side of the house or building
which favours more shade than sunlight. If the unit
is in direct sunlight, it is advisable to provide an
awning over the unit.
D) Provide sufficient clearance around the cabinet
to allow for ample air circulation through the unit
(See Fig. 2). The rear of the unit should be
outdoors and not in a garage nor inside a building.
Keep unit as far away as possible from
obstacles/obstructions and at least 30" above
the floor or ground. Curtains and other objects
within a room should be prevented from
blocking the air flow.
E) Be certain the proper electrical outlet is
within reach of the installation. Use only a
single outlet circuit rated at 15 amps. All wiring
should be in accordance with local and
national electrical codes.

INSTALLATION

Scissors
Carpenters Level

INSTALLATION HARDWARE

3/4" screws (9)
3/8" screws (4)
Frame Lock
(2)
Side Curtain RH (1)
Side Curtain LH (1)
Fig. 1
F) DO NOT install unit where leakage of
combustible gas is suspected. Your air
conditioner may fail to operate in air containing
oils (including machine oils), sulfide gas, near
hot springs, etc.
20"
Min
Side
Obstruction
Ground
Fig. 2
Your unit is designed to evaporate condensation
under normal conditions. However, under extreme
humidity conditions, excess condensation may
cause basepan to overflow to the outside. The unit
should be installed where condensation run-off
cannot drip on pedestrains or neighboring properties
5
Safety Lock (1)
Adhesive
Foam Seal (1)
Regular Foam
Seal (1)
Awning
12" Min
20"
Min
Fence,
30"
wall, or
Min
other
obstacle