Fork Installation; Installation Instructions - SR Suntour COIL SPING Serie Mode D'emploi

SR SUNTOUR - OWNERS MANUAL
►Check the cable length and routing of your
components. Make sure they do not interfe-
re your steering actions.
►If you are using reflectors for on-road cyc-
ling, make sure they are clean and properly
installed.

FORK INSTALLATION

WARNING!
SR SUNTOUR strongly recommends that your fork is being installed by a trained and qualified
bicycle mechanic. Special knowledge and tools are essential to install SR SUNTOUR forks.
Common mechanical knowledge may not be sufficient to install a SR SUNTOUR suspension
fork. If you intend to install the fork by yourself, the whole job has to be inspected by a
trained and qualified bicycle mechanic. Please note, that improperly installed forks are
extremely dangerous and can cause damage to the product, serious injuries or even death.

INSTALLATION INSTRUCTIONS

Note! All fixing bolts have to be tightened with the proper fasting torque stated by the
manufacturers
1. Remove the existing fork from your bicycle. Afterwards remove the crown race from the
fork.
2. Measure the length of your old fork's steerer tube against the length of the SR SUNTOUR
fork steerer. SR SUNTOUR suspension forks are delivered with a standard steerer tube
length of 255mm. Therefore the steerer tube may need cutting to the proper length.
FORK INSTALLATION
3. In order to define the proper length of your steerer tube you can apply the
following formula:
Frame's head tube+Head sets stack height+Spacers+Stem's clamp height-
If your SR SUNTOUR fork does come with a threadless steerer tube, do not add a
thread to it. SR SUNTOUR'S fork steeres are a one time press fit which can not be
removed. Do not try to replace the steerer tube by a steerer tube with a threaded
steerer. This will void the warranty of your fork and result into a failure of the
6
English
NRX / NCX LITE / NCX / NVX / NEX / CR9V / CR8V V2
product or could cause fatal injuries or even death to the rider.
►Bounce your bike slightly on the ground
while looking and listening for anything
which might be loose.
►In case you are going to mount a low-rider
on your fork, your bikes performance may
handle differently according to the additio-
nal weight. Follow the instructions given by
the manufacturers of your low-rider. Make
sure not to overstrain your low-rider. This
could also result into a failure of your SR
SUNTOUR suspension fork.
Warning!
3mm clearance