Before Each Ride; Installation Instructions - SR Suntour SP8 NCX Mode D'emploi

SR SUNTOUR - OWNERS MANUAL

BEFORE EACH RIDE!

► Make sure your seatpost is fastened with the proper torque value according to the
frame's/seat clamb's specifications. If you are using a quick release seat-clamp
make sure it is closed properly. A not properly closed seat-clamp bears the risk that
your seatpost starts twisting while riding. This implies the risk of an accident and
fatal injuries.
► Make sure the screws which are securing the saddle are fastened with the proper
torque value (12Nm). A loose saddle might result into an accident and/or fatal
injuries.

INSTALLATION INSTRUCTIONS

We strongly recommend that your seatpost is getting installed by an qualified and trai-
ned bicycles mechanic. Improper installation can result in failure of the product, accident,
injuries or even death. If your are going to install the seatpost on your own, the whole job
should be inspected by an trainend and qualified bicycle mechanic. The inspection needs
to be confirmed by the dealer signing this owners manual on the back side of it. Additionally
1.Remove your old seatpost
2. Clean the inside of the seat tube to make sure no old grease or dirt stays inside. You also should
make sure that the seat tube itself has no burrs which could scratch the seatpost. If so you have to
remove this overlap in order to slide the seatpost in very smoothly.
3.Grease the seat tube; if you are using seatpost shims you have to grease them from the inside
and the outside
4. Install your seatpost and insert it past the „MIN INSERT" mark (pic 1.1) and at least 10mm past
the joint of top and seat tube (pic. 1.2)
SR Suntour
MIN
INSERT
2
27.2
English
an official stamp of the dealer's shop is required.
pic 1.1
MIN INSERT
MARK
SP8 NCX / SP8 NEX
pic 1.2
At least 10mm past
this point