Table des Matières
Publicité
Care and maintenance
• After use the appliance must be emptied; never store the spray-liquid in the sprayer.
• Unscrew the pump and empty the tank.
• The appliance must be washed out using a suitable agent and then rinsed with clean water; do not use hot water (max.
30°C / 86°F).
• Store the equipment away from the effects of frost. For storage the spray-tube may be hooked onto the pump handle.
• Particular attention must be given to parts which are subject to wear, such as the nozzle and gaskets. The nozzle (15) must
be cleaned periodically. These parts are easily replaceable.
• Periodically apply a little oil to the piston-rod, the thread of the pump-tube and the O-ring (5) (see -> oil). Screw in the pump
only loosely when the appliance is not in use.
• Do not clean the nozzle with hard objects, nor blow through it using the mouth. The most suitable cleaning device is a nail-
brush or tooth-brush.
• To dry the sprayer, place it upside down, without the pump (4), and leave it standing open to the air.
Troubleshooting measures
Cause
• Pressure in tank decays
Air pump, pressure gauge, hose lines not
adequately tightened down or gasket damaged
• Hose torn or punctured
• Tank defective or strongly dented
• Revolver valve stuck
Valve dirty
• Valve spring weak
Revolver valve leaking
• Wand nozzle spray irregular
Nozzle clogged
Nozzle bore eroded
Spare parts and repairs
If any part shows signs of damage or wear, replace it immediately. Use only BIRCHMEIER original parts (see spare parts list).
Guarantee
• We make a warranty of 12 months from the date of sale. During this warranty period we will repair free of charge defects of
the sprayer which are due to deficiencies in material and manufacturing, either by repair of replacement of parts, or of the
entire sprayer.
• Prerequisite to the honoring of warranties is the appropriate storage and use of our equipment strictly in accordance with
the operating instructions which were valid on delivery (including the instructions given on the appliances themselves).
These instructions constitute an integral part of our contract. Any and all damages which fall within our scope of
responsibility must be reported to us in writing immediately after they have been discovered.
• Expressly excluded from the warranty and liability are damages and deficiencies:
• Resulting from the non-adherence to our instructions and usage recommendations in the operating manuals such as the
improper use or inadequate maintenance of our equipment;
• Resulting from chemical attack, or due to normal wear;
• Due to damages, the causes of which are beyond the scope of our responsibility and influence, e.g. mechanical damage,
force majeure.
• The warranty becomes null and void and any and all liabilities are disclaimed if the user or any third party alters or makes
inexpert repairs to the sprayer.
• Excluded from the warranty and liability are all incidents which extend beyond the obligations set forth above. Any and all
liability is expressly excluded to the extent of the law. Expressly excluded is in particular any and all liability for damages
which are purely asset-related such as lost profit, loss of use, operating outage etc.
Place of jurisdiction: Baden, Switzerland
Applicable law:
Swiss law
• For any further information concerning use or maintenance of the equipment please refer to your dealer.
Technical data
Permissible operating pressure
Permissible operating temperature
Tank volume
Maximum tank contents
Spraying-rate at 4 bar
Data on materials
Empty weight
Remedy
Adequately tighten down air pump, pressure gauge and
hose line or change damaged gaskets
Change hose
Change tank (Repair work is prohibited)
Disassemble revolver valve, thoroughly clean,
grease valve rod and reassemble
Change valve spring
Change gaskets
Clean nozzle
Change nozzle
4 bar max.
5°C - 30°C
7.5 litres / 9.9 litres
5 litres / 7 litres
0.91 litre/min
Plastics of PP, PA and PE-HD
Elastomers of Viton (FPM) and PVC
Metals of brass
2.7 kg
(max. 58.02 psi)
(41°F - 86°F)
(1.95 US Gal / 2.57 US Gal)
(1.30 US Gal / 1.82 US Gal)
(0.23 US Gal / min.)
Publicité
Table des Matières
