Kreg KMA4500 Mode D'emploi page 9

2 Align the Guide Rail to the Marks
a. Place the guide rail on your material. Align and position the guide rail to your
reference marks. Refer to Step 2 from the Operation section of the manual for
proper alignment of the clamps to the material's edge.
Attention This is the only time that you will align the guide rail to your marks. After
calibration, the cutline indicator arms will align to your measured marks as indicated
in Step 2 of the Operation section of the manual.
b. Secure the guide rail in place. Refer to Step 3 from the Operation section of the
manual to secure and clamp the guide.
C
9