Kreg KMS7215 Mode D'emploi

Micro-Adjuster
Instructions
Item# KMS7215
Insert the ¼" x 1-1/4" T-bolt (FT4212)
1.
through the hole in the bottom of the Micro-
Adjuster assembly (SUB-MICRO-ADJ) so it
protrudes through the top of the assembly.
Place the 1/4" Brass Washer (DK1504) over
the threads of the T-bolt and attach the black
T-knob (DK1313) but do not tighten.
1/4" Brass Washer
(DK1504)
1/4-20 x 1-1/4
T-Bolt
(FT4212)
Using the Micro-Adjuster is simple. Once you have positioned your fence close to the desired position, lock down the Micro-Adjuster by tightening the black
T-Knob. Rotate the Thumb Wheel on the Micro-Adjuster to make fine adjustments to the fence's position. The Micro-Adjuster's Thumb Wheel was engineered so
each mark on the Thumb Wheel represents 5/1000 of an inch of movement for the fence, allowing you to set the exact fence location you want.
When using the Micro-Adjuster to adjust the position of your fence, make sure the fence is NOT locked in place. After you have positioned your fence exactly
where you want, be sure to tighten down the Clamp Block before placing any material against the fence.
Precision Band Saw Fence
Thank you for purchasing our Precision Micro-Adjuster for use with the Kreg Precision Router Table
Fence and Band Saw Fence. The Micro-Adjuster's unique design allows you to make fast and precise
fence adjustments in increments of 5/1000 of an inch, with the simple turn of the Thumb Wheel.
Attaching the Micro-Adjuster
Insert the head of the ¼" x 1-1/4" T-bolt
2.
into the T-slot of the Fence Mounting Rail
and slide the Micro-Adjuster towards the
Clamp Block.
Black T-Knob
(DK1313)
SUB ASSEMBLY
FOR KMS7215
(SUB-MICRO-ADJ)
How to Use the Micro-Adjuster
www.kregtool.com • 800.447.8638
WARNING:
This product can expose you to chemicals including
lead, which is known to the State of California to cause cancer, birth defects
or reproductive harm. For more information go to www.P65Warnings.ca.gov.
Align the threaded screw of the Micro-
3.
Adjuster with the accessory hole in the
Clamp Block. Thread the Micro-Adjuster
screw into the Clamp Block by rotating the
Micro-Adjuster Thumb Wheel until the screw
is roughly 3/4 of the way threaded into the
Clamp Block.
Now you are ready to use the Precision
Micro-Adjuster.
Precision Router Table Fence
Item# PRS1010
FT4178
Version 6 - 05/2018