Calibration - Kreg KMA4500 Mode D'emploi

Calibration

The indicator arms can be reversed based on left- or right-bladed saws. If your saw
has a blade mounted on the left-hand side, install the indicator arms so the flat faces
are positioned on the left side of the guide rail (as shown on previous page in step 7).
If your saw has the blade mounted on the right-hand side, reverse the positioning so
the flat face of each indicator arm is on the right side of the guide rail.
Note Indicator arms are long and will cover the distance from the blade to the
baseplate edge of the most saws, between 1" – 5.5".
1 Position the Saw and Make Reference Marks
a. Ensure the saw is unplugged or the
battery is removed. Set the blade
depth of the saw to the material
allowing for 1/8" more than material
thickness. See your saw owner's
manual for setting the depth.
b. Lift the blade guard to expose the
blade, and position the saw on a
piece of plywood so that the blade
rests against the plywood edge.
c. Mark a line on the material of where
the baseplate edge rests.
d. Repeat steps a - c at the far side of
the material.
8