Connecting Up; Easy Setup - Marantz DV8300 Mode D'emploi

Connecting Up

2

Easy Setup

This easy setup is the minimum set of connections you
need to start watching DVD video discs. Both sound and
picture are fed directly to your TV using the supplied
Audio/Video cable. For other possible connections, see
pages 28 and 32.
1
Connect to a composite video
input on your TV using the
supplied yellow video cable.
Y
C /P
B B
C /P
R R
VIDEO
COMPONENT
VIDEO OUTPUT
2
Connect to a pair of stereo audio inputs on
your TV using the supplied Audio/Video
cable.
Connecting Audio/Video cables
Be sure to insert each plug fully for
the best connection. The plugs and
jacks are colour-coded to make
connection easier.
Important
• In order to properly ground this player, you must connect at
least one audio or video cable (not including an optical cable)
in addition to the control cable.
Connecting system control cables
By connecting this DVD player to another Marantz audio
component using a supplied System Control cable, you can
remotely operate the components as a single system.
• When connecting to component with a remote sensor (such as
the SR8200, SR7200), be sure to connect the REMOTE
CONTROL IN jack of this DVD player to the REMOTE CON-
TROL OUT jack of the component with the remote sensor.
24
En
EXTERNAL
TV A/V EUROCONNECTOR AUX
1 2 S1/S2 IN OUT OPTICAL COAXIAL
EXTERNAL INTERNAL
DIGITAL
REMOTE CONTROL
OUTPUT
Important
Before making or changing any rear panel connections, make sure
that all components are switched off and unplugged from the wall
outlet.
INTERNAL
L L CENTER
R R SUB W.
1 2 SURR.
FRONT
AUDIO OUTPUT
3
Plug into a standard AC
wall outlet.
• When connecting to component which is not equipped with a
remote sensor, be sure to connect the component to the
REMOTE CONTROL OUT jack of this DVD player.
Synchronized power on and off
• Connect with the remote control output jack of a component
(such as the SR8200, SR7200) which is compatible with
Marantz remote control system. The remote control allows to
switch the power of this DVD player to "POWER ON and
Standby mode".
Note
Be sure to leave power switch on the Front panel in the
power mode.
Remote switch
• When using this DVD player independently, set this switch to
INTERNAL. When using this DVD player in a system with a
Marantz receiver equipped with a remote sensor, set the switch
to EXTERNAL.