Publicité
Les langues disponibles
Les langues disponibles
Installing the Outdoor Sensor:
Find an appropriate place for the outdoor sensor, protected from rain and direct sun light.
Note: Please ensure that you install the outdoor sensor within a radius of maximum 60m (open area) from the weather station. Check that there are no obstacles
between the outdoor sensor and the weather station. Otherwise there may be interference of the transmission of data.
For wall mounting:
Hang the outdoor sensor with the mount (42) on one screw.
Preparing the weather station for use
Open the battery compartment (40) on the back of the weather station.
Insert 2 x AA batteries accordingly to right polarity (+/-).
Then close the battery compartment.
As soon as the battery safety strip has been removed, the weather station starts to
receive the radio signal.
Note: Do not move the weather station while it is receiving the signal. This may disrupt reception.
Connecting the weather station with the outdoor sensor and the DCF radio signal:
After installing of batteries, the weather station attempts to establish a connection with the outdoor sensor. This process can take a few minutes. The symbol will
keep flashing for few minutes. On successful connection with the outdoor sensor, the selected channel symbol (27) appears in the LC display with the channel of
the outdoor sensor (if necessary you can change the channel of the outdoor sensor as shown in the section "Setting the channel"). If the connection with the
Publicité
