Oregon Scientific WS6762 Mode D'emploi page 38


Press and hold the MODE button for 2 seconds ,the flashing alarm time is shown

The hour display of the alarm time is flashing. Use + or – button (35), (36) to select the hour.

Press MODE button to confirm.

The minute display of the alarm time is flashing. Use + or – button to select the minute.

Press MODE button to confirm.

Then press MODE button to switch from A1 display to ALARM 2 display

The setting sequence for ALARM 2 is the same as for ALARM 1.
Note: Press and hold the + or – button to accelerate the setting of values.
Activating / deactivating the alarm function

Briefly press the MODE button (34) briefly once or twice to reach ALARM 1 or ALARM 2 mode.

Press the + button (35). The ALARM 1 symbol (3) or ALARM 2 symbol (8) appears in the LCD display. The alarm has been activated.

Press the button + again. The ALARM 1 or ALARM 2 symbol in the LCD display goes out. The alarm has been deactivated.
Switching off the alarm signal
Press any button except the SNOOZE- /LIGHT button (33) to stop the alarm signal. It is not necessary to reactivate the alarm. It switches itself automatically to
the alarm time which has already been set.
Note: The alarm signal sounds for approx. 2 minutes.
SNOOZE function