Front Brake Lining Control; Brake Disc Thickness Control - Beta Motorcycles RR 125 LC Mode D'emploi

4

FRONT BRAKE LINING CONTROL

2 mm
In order to verify the wear condition of front
brake is enough to view the caliper from
the top, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let's start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 60.
To replace, contact authorised Betamotor
customer service.
BRAKE DISC THICKNESS
CONTROL
Periodically verify disc condition. In case
signs of damage , veins, or deformations
are present, proceed with replacement.
Verify disc thickness. The minimum thick-
ness is engraved on the disc.
Once the limit is in proximity or has been
reached, proceed with brake disc replace-
ment.
For replacement, contact an authorised
Betamotor after-sales service centre.
EN
44