Replacement; Oil Filter Replacement - Beta Motorcycles RR 125 LC Mode D'emploi

REPLACEMENT

Always renew the oil while the engine
is hot:
- Place a container under the engine
- Unscrew filler cap 1 and drain plug 2
- Empty the crankcase completely
- Clean the oil filter on top of the drain
plug
- Close plug 2
- Add the following amount of oil:
0,95 l without oil filter replacement
1 l with oil filter replacement
- Verify the level as described above
- Screw on filler cap 1 again.
WARNING:
Hot oil can cause severe burns!
WARNING:
Dispose of used oil in compliance with local regulations.
NOTE: For subsequent oil changes, follow the instructions given on the chart on
page 60, using the lubricants recommended on page 16.

OIL FILTER REPLACEMENT

- Unscrew the three fixing screws 1 to
remove the oil filter element cover 2 and
the oil filter element 3.
- Install a new O-ring 4.
- Install a new oil filter element and the
filter cover.
3
4
2
41
2
2
1
4
EN