Technical Specifications; Protect The Environment - Anglecare AC417 Manuel Du Propriétaire

TECHNICAL SPECIFICATIONS

Range:
Open field (Open area without obstructions):
up to 820 feet (250 meter).
Number of Channels:
USA/Canada: 24 channels.
Europe: 24 channels.
Power Supply:
1 included Li-Ion battery (Parent Unit)
100 - 240 VAC / 5 VDC adapter for the Parent Unit
100 - 240 VAC / 5 VDC adapter for the Camera
1 included CR3032 3V battery (wireless Sensor Pad)
Caution: To reduce the risk of electric shock, do not expose this product
to rain or moisture.
Danger of explosion if batteries are incorrectly replaced. The battery
included for the Parent Unit is a user replaceable Li-ion rechargeable
battery, manufactured by manufatured by Icon Energy System (Shenzhen)
Co Ltd. Only use the Angelcare recommended replacement battery. To
®
obtain information on replacement batteries please contact Angelcare
customer service: www.angelcarebaby.com or contact your local
distributor. Instructions will be included with the replacement battery. Keep
all batteries away from children.
SAR Information Statement
Your baby monitor Parent Unit is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits
for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are
part of comprehensive guidelines and establis permitted levels of RF energy for the general population. The guidelines are based on
standards that were developed by independent scientific studies. The standards include a substantial safety margin designed to
assure all persons, regardless of age and health. The exposure standard for the Parent Unit employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Test for SAR are conducted with the Parent Unit
transmitting at its highest cetified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the Parent Unit while operating can be
well below the maximum value. This is because the Parent Unit is designed to operate at multiple power levels so as to use only
the power required to reach the Nursery Unit. In general, the closer you are to Nursery Unit, the lower the power output. Before a
baby monitor model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit
established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., in
front of face and worn on the body) as required by the FCC for each model. The highest SAR value for the Parent Unit when tested for
use in front of face is 0.043W/Kg and when worn on the body is 0.125W/Kg (Body-worn measurements differ among various models,
depending upon available accessories and FCC requirements). While there may be differences between the SAR levels of various
Parent Units and various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment
Authorization for this model Parent Unit with all reported SAR levels evaluated in compliacne with the FCC RFexposure guidelines.
SAR information on this model Parent Unit is on file with the FCC and can be found under the Display Grant section of http://www.fcc.
goc/oet/fccid after searching on FCC ID:N7TAC117R
In the United States and Canada, the SAR limit for the Parent Unit is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The
standard incorporates a substantial margin of safety to give additional protection for the public and to account for any variations in
measurements.
IC STATEMENT
This device complies with Industry Canada licence-exempt RSS standard(s)
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, inluding interference that may cause undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for satisfying RF exposure compliance. This transmitter must not
be co-located or operation in conjunction with any other antenna or transmitter.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue.
The highest SAR value for this Parnet Unit when tested for use in front of face is 0.043W/Kg and when worn on the body is 0.125W/
Kg. This device was tested for typical body-worn operations. To comply with RF exposure requirements, 0mm testing separation
distance was done between testing BODY and the Parent Unit, including antenna. Third-party belt-clips, holsters, and simialr
accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied antenna.
Batteries:
• CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE.
Transmission:
Transmission between the Parent Unit and the Camera is made on 2.4 GHz
Transmission between the Camera and the Sensor Pad is made on 2.4 GHz
Maximum RF Power Transmitted:
• 20dBm (100mW) between Camera and Parent Unit
• 20dBm (100mW) between Camera and Sensor Pad

PROTECT THE ENVIRONMENT

The wheelie bin symbols mean that according to local laws and
regulations your product and/or its battery shall be disposed of
separately from household waste. When the product/battery reaches
its end of life take it to a collection point designated by local authorities.
The seperate disposal and recycling will help conserve natural resources
and protect human health and the environment. Refer to User's Guide for
removal of batteries.
®
E
N
19