Anglecare AC417 Manuel Du Propriétaire page 17

1
18°C
LOSS OF CONNECTIVITY BETWEEN THE SENSOR PAD AND THE CAMERA
• If your Sensor Pad becomes un-paired from your Camera, please follow the steps below to re-pair them.
2
NO SOUND IS BEING TRANSMITTED
• Check the volume level on the Parent Unit and the Camera to ensure they are set to an appropriate level.
• Try bringing the Parent Unit closer to the Camera to see if you get sound.
• Charge the Parent Unit.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby's reach.
• Recharge the Parent Unit.
STATIC, DISTORTION, INTERFERENCES
(FROM OTHER MONITORS, WIRELESS PHONES, WALKIE-TALKIES, ETC.)
• Rotate Parent Unit or move it away from source of interference.
1) Turn OFF your Parent Unit & Camera Unit.
2) Turn ON your Parent Unit & Camera Unit.
3) Tap the Settings icon
4) Press the Bin icon
5) Press the tick/Bin icon - this icon will disappear and press the
press the
4
6) Press and hold the Pause / Pairing button on the top right of
the Camera for 2-3 seconds.
7) When the Bin icon
68°F 18°C
18°C
3
to open the Pairing Screen
to see a tick
that will show in its place. If however there is no Bin icon,
on the Parent Unit. It should turn blue.
The Parent Unit Power Indicator will
flash to indicate it's in linking mode.
appears, the Camera is paired.
1) Tap the Settings icon
2) Tap the Pairing icon
menu.
3) Tap Bin icon
to delete the paired Sensor Pad and
tap again on the tick
Sensor Pad. If however there is no Bin icon, press
the on the Parent Unit. It should turn blue.
4) When the Bin icon
paired.
appear next to this icon.
in the video display view.
to enter the device pairing
. Tap the icon to pair the
The Parent Unit Power Indicator will
flash to indicate it's in linking mode.
appears, the Sensor Pad is
E
N
.
17