Patchcords & Jumpers; Network Communication; Ip Address; Smtp Address / E-Mail Notification - JDSU OTU-8000 Manuel Utilisateur

Chapter 1 Prerequisites and delivery of the OTU-8000
Prerequisites of the OTU-8000
Patchcords & jumpers

Network Communication

IP address

SMTP address / E-mail
notification
6
In this case, the converter is already wired to a female 5-point
connector.
Fig. 6 Converter with female connector delivered
Converter specifications
AC Input: 100-240 V, 2A, 50-60 Hz
DC Output: -48V, 2.5 A
The jumpers used to connect the OTDR to the optical switch are
provided. Patchcords to the ODF are not supplied
NOTES
Connectors are SC type. PC or APC connectors are available.
One patchcord is necessary for each fiber to connect to a testing
port.
Make sure you have the correct cables, connectors and required infor-
mation to setup and configure the network access.
To establish the communication between the OTU-8000 and the server,
you must get all necessary information concerning the IP address:
– IP address
– Subnet Mask
– Gateway
This information should be provided by your system manager.
You must get the SMTP address from your mail server. The OTU-8000
will use this information to send e-mails in case of alarm.
NOTE
Sending e-mail is only used when the server is not reachable.
1.They may be ordered separately
User Manual 7OTU80010/06
1
.