Otu-8000 Power Supply; Otu-8000 Consumption; Section Of Electric Wires; Ac Power Supply - JDSU OTU-8000 Manuel De L'utilisateur

Chapter 1 Prerequisites and delivery of the OTU-8000
Prerequisites of the OTU-8000

OTU-8000 Power Supply

OTU-8000 Consumption

Section of electric wires

AC Power supply

Patchcords & jumpers

Network Communication

Network access

4
Your local electrical installation must comply with the OTU-8000 power
consumption:
– DC Input: -36 to -60V
– Power consumption: 35W
Electric wires plugging into the OTU-8000 must have a section inferior
or equal to 1,5mm².
The OTU-8000 works on -48V DC power. The OTU-8000 can be deliv-
ered with the specific AC to DC converter, if ordered as an option (Ref:
E98ACDC).
In this case, the converter is already wired to a female 5-point
connector.
Fig. 4 Converter with female connector delivered
Converter specifications
AC Input: 100-250 V, 2A, 50-60 Hz
DC Output: -48V, 2.5 A
Do not use any converter or power cord other than those
supplied by JDSU as an option for the instrument.
The jumpers used to connect the OTDR to the optical switch are
provided. Patchcords to the ODF are not supplied.
Make sure you have the correct cables, connectors and required infor-
mation to setup and configure the network access.
The cable used to connect the OTU-8000 to Ethernet
ethernet cable with a RJ45 connector. This cable is not delivered with
2
the OTU-8000 .
1. This connection is necessary unless you ordered the PSTN option
2. Unless you specifically order it to JDSU
User Manual 7OTU80050/01
1
is a regular