5.4
Adjusting the drawers
The refrigerator comes with two drawers that have been adjustable to provide proper operation and a
good exterior appearance with a proportioned tile layout.
In the event that the drawers need to be adjusted, proceed as follows.
Open the drawer and remove the metal clip on the inner side.
Use the screws indicated to raise or lower the drawer (screw 1) or to move the side to the left or the right
(screw 2).
Fig. 5.14
Screw 3 releases the drawer front. Danger of the door falling.
Use this screw only with due care and attention.
5.5
Fixing the thermostat display (only for no inox panel version)
In the version without inox panel the digital thermostat display will be supplied as kit like shown in the
figure below:
The display dimensions are shown in the figure 5.17. We recommend to realize a suitable seat for the
display housing in the front panel used to cover the drawer.
1
2
Fig. 5.15
Fig 5.16
1
Inox frame
2
Command display
3
Display extended cable
52
3