Types Of Recess; Fixing The Cabinet; Defrost Water Drain - Vitrifrigo DRW Serie Manuel D'installation

5.2

Types of recess

For the whole series (except the no inox panel versions) is possible to install the cabinet in the two ways
below:
•
Total recess (door inside - door flush with the front side of the fixing profile): prepare the profile
and the base profile, supplied as a kit, as shown in the diagram using the screws already installed
(see single arrows).
•
Partial recess (door outside - door closes proud of the front side of the fixing profile): prepare the
profile and the base profile, supplied as a kit, by making it slide in the direction of the double
arrows.
5.3

Fixing the cabinet

5.3.1 Defrost water drain

In the model without automatic disposal of the defrost water (model with remote refrigerant unit) connect
the drainpipe fig. 5.9 (with inner diameter of 12 mm) to the water disposal network before fixing the
cabinet.
Fig. 5.8
Fig. 5.9
49
EN