Sportplus SP-TM-1006 Mode D'emploi page 34

Troubleshooting – Problems with the computer display
Warning, Risk of injury
Improper repairs can result in significant hazards for the user. Any repairs or
replacements must be carried out by a technically experienced person.
Error
Cause
message
The display has not
Er 01
received the signal.
Over-
Er 03 voltage
protection
Er 04 Over current
Er 05 Overload
SP-TM-1006-IM-V02-INT.indb 34
Troubleshooting and additional measures
1. Check if the communication cable is loose,
detached or damaged.
2. Check or replace the display.
3. Check or replace the controller.
Check if the voltage
to the power cable
is normal: AC 200-
240 V.
- Check or replace
the controller.
- Check or replace
the motor.
- Please contact our
customer service.
1. Check for over current.
2. Check if any mechanical parts are sticking.
3. Check if a lubricant is missing or whether friction
between the belt and housing increases if lubricant
is missing.
4. Check if the board is worn.
5. Check if the drive belt is worn.
6. Check if there is short-circuit in the motor
connection.
7. Check or replace the controller.
8. Check or replace the motor.
- Please contact our customer service.
Check if the
walking belt is
stuck or stopped by
something.
Check the loading.
34
Replace the speed sensor
cable.
Replace the sensor.
Replace the motor control
board.
Apply small amount of
lubricant provided on the
running deck.
Replace the motor.
Replace the motor control
board.
4/12/2021 4:31:42 PM