Sygonix 1593775 Notice D'emploi page 54

"Heating" and "Cooling" control
The device can be used as a two-point controller for heating and cooling
appliances. In heating mode (5), the appliance switches off when the target
temperature is exceeded. In cooling mode (6), the appliance is switched off
when the temperature drops below the target. The mode is indicated by a flame/
snowflake symbol. You can also configure a 5-minute delay. This activates a
switching hysteresis to prevent the connected systems from switching on (NO)
and off (NC) too quickly.
"Heating" control "Cooling" control
Go to the function menu to configure the settings. Use the SELECT button to
select "Ht". Press SET to confirm. Use the SELECT button to select "Ht" for
heating or "CL" for cooling. Press OK to confirm.
Press and hold the SET button for 3 seconds to enable the delay function. Press
the SELECT button to switch from the time settings ("ti") to the function settings
("St"), and then press SET to confirm. Press the SELECT button to switch from
holiday mode ("Ho") to heating/cooling control ("Ht"), and then press SET to
confirm. Press the SELECT button to switch from heating mode ("Ht") to cooling
mode ("CL"), and then press SET to confirm. Use the SELECT button to turn the
delay on ("d:ON") and off ("d:OFF"). Press the OK button to save the settings
and exit the menu.
54